Malaysia Troubleshooting Guide for A800SE / A810 / A400 / A500S / M310
If your 70mai dashcam doesn’t power on automatically after parking overnight, don’t worry — this issue is very common among Malaysian drivers. In most cases, the cause is not a faulty dashcam, but power supply issues, car battery conditions, wiring problems, or parking mode protection.
This guide explains the real reasons, how to troubleshoot them, and how to prevent the problem from returning.
1. Common Symptoms Reported in Malaysia
- Dashcam stays off in the morning
- Parking mode did not record anything overnight
- Device only turns on after pressing the power button
- Random shutdowns during driving
- Reboots when hitting bumps or uneven roads
These symptoms point to unstable power delivery.
2. Main Reasons Your Dashcam Fails to Power On
2.1 Weak Car Battery (Very Common in Malaysia)
Malaysia’s hot climate shortens battery lifespan.
When the battery voltage drops overnight, the dashcam may not receive enough power to start.
Signs your battery is weak:
- Engine cranks slowly
- Battery older than 18–24 months
- Short-distance driving daily
- Lights dim during startup
Low voltage = dashcam does not power on.
2.2 No Hardwire Kit Installed
If your dashcam uses the cigarette lighter socket:
- Some cars cut power immediately after shutdown
- Some cars only provide power after ignition
This causes inconsistent startup the next morning.
Solution: Install the 70mai Hardwire Kit for stable power.
2.3 Parking Mode Voltage Protection Triggered
The hardwire kit cuts off power when voltage drops below 11.4V to protect your battery.
If your battery is weak → power is cut overnight → dashcam cannot turn on the next morning.
This is normal and common in Malaysia due to heat and short trips.
2.4 Incorrect Wiring / Wrong Fuse Tapping (Power Not Stable)
One of the most common causes among dashcam users in Malaysia is improper wiring.
If ACC, BAT+ or GND are connected wrongly, the dashcam receives unstable or insufficient voltage.
Symptoms of incorrect wiring:
- Dashcam turns off randomly
- No auto power-on in the morning
- Parking mode sometimes works, sometimes doesn’t
- Power cuts when hitting bumps
Wiring issues must be corrected by a skilled installer.
2.5 SD Card Problems
A corrupted or slow SD card can freeze the dashcam during boot.
Use only:
- V30-rated cards
- High-endurance SD cards
Avoid cheap cards — they fail quickly in Malaysia heat.
2.6 Extreme Heat (Overheat Protection)
Inside a parked car, temperatures can reach 60–70°C.
When overheated, the dashcam may delay startup until it cools slightly.
3. How to Fix the Issue Immediately
- Start your engine and wait a few seconds
- Press and hold the power button to attempt manual startup
- Check if your cigarette socket has power during ignition
- Look at the Hardwire Kit LED:
- Green = normal
- Red = low voltage
- Remove the SD card and try powering on again
- Perform a battery load test at any workshop
Most problems are resolved by step 4 or 6.
4. How to Prevent This in the Future
- Install 70mai Hardwire Kit
- Replace weak or old car batteries
- Use proper V30 high-endurance SD cards
- Ensure wiring is correct: ACC + BAT+ + GND
- Avoid inexperienced installers
Stable wiring + healthy battery = zero morning problems.
5. Recommended Products for Malaysia Drivers
- 70mai A810 – Best 4K night vision
- 70mai A800SE – Best price-to-performance Super Capacitor
- 70mai Hardwire Kit Up 03– To enable 24/7 parking mode
- 70mai 4G Hardwire Kit-To enable 4g features
Need Help?
If you’re unsure whether the problem is wiring, battery, SD card, or your dashcam:
📲 WhatsApp us: 6011-2050 3370
We can help diagnose the issue and recommend the right solution.
